HDi Ford PX3 Ranger biturbo intercooler GT2 complete intercooler is an HDi high-efficiency GT2 core measuring 670mm x 260mm x 70mm, designed to replace a regular Chemical polished factory unit and provide greater airflow potential, resulting in increased performance and reduced mileage.
Installation: Installing the HDi Ford PX3 biturbo GT2 complete intercooler kit is simple. It can be easily installed with basic workshop tools, making the installation a quick and easy process that typically takes less than 40 minutes.
Performance Guaranteed: After hundreds of hours of design and testing, Dyno tests have shown improvements of 6-15 horsepower and 10-20 Nm of torque throughout the RPM range!
Only Ford Everest includes a hot pipe and cold pipe for fitting!"
HDi Ford PX3 Ranger biturbo GT2 upgrade intercooler
The HDi Ford PX3 Ranger biturbo intercooler GT2 complete intercoolerbenefit as below:
? Improved low end throttle response (refer dyno)
? Minimal pressure drop despite large intercooler sizing (thanks to HDi GT2 technology)
? Increased torque range at low end (refer dyno)
? Reduction of both inlet temperatures
? less engine running temperatures
? Increased performance
? Better reliability and consistency
? Increase power throughout entire RPM range (not only focusing on the PEAK)
? Improve fuel efficiency*
? Best value for money
? Performance guaranteed!Full stainless steel screws and brackets the best durability against water and salt corrosion.
The special design allowing enough area for aftermarket 4wd winch to be installed
It also allows good air flow to the radiator!
*The reduced inlet restriction and inlet temperature provides higher density of oxygen for better combustion with the same amount of fuel. Hence, increase mileage
